Or type "exit" to exit without saving configuration parameter entries Let's change the IP address, subnet mask, and default gateway: > ip: 10.50.100. Type "?" for HELP, "/" for current settings or "quit" to save-and-exit.
HP JETDIRECT 170X MOTOM MAC
: F.08.20 MAC Address : 00:01:e6:28:03:e0 Config By : USER SPECIFIED IP Address : 10.50.100.8 Subnet Mask : 255.255.255.0 Default Gateway : 10.50.100.82 Syslog Server : Not Specified Idle Timeout : 90 Seconds Set Cmnty Name : Not Specified Host Name : Not Specified DHCP Config : Disabled Passwd : Disabled IPX/SPX : Disabled DLC/LLC : Disabled Banner page : Enabled > ? To Change/Configure Parameters Enter: Parameter-name: value Parameter-name Type of value ip: IP-address in dotted notation subnet-mask: address in dotted notation (enter 0 for default) default-gw: address in dotted notation (enter 0 for default) syslog-svr: address in dotted notation (enter 0 for default) idle-timeout: seconds in integers set-cmnty-name: alpha-numeric string (32 chars max) host-name: alpha-numeric string (upper case only, 32 chars max) dhcp-config: 0 to disable, 1 to enable allow: (0 to clear, list to display, 10 max) addrawport: ( 3000-9000) deleterawport: listrawport: (No parameter required) ipx/spx: 0 to disable, 1 to enable dlc/llc: 0 to disable, 1 to enable banner: 0 to disable, 1 to enable Type passwd to change the password. HP JetDirect Please type "?" for HELP, or "/" for current settings > / =JetDirect Telnet Configuration= Firmware Rev.
HP JETDIRECT 170X MOTOM HOW TO
How to check the current IP: attach a PCL compatible printer, press the test button on the 170X and this should tell you what IP address the 170X currently has.Ĭhange IP (You may can not see what you typed in telnet windows but don't worry just go ahead. The default address after reset is 192.0.0.192 so you need a crossover cable if you are plugging the JetDirect into a PC, and a normal cable if using hub or switch. See Appendix A for technical specifications, supported environments, and accessory part numbers. The router/modem is (UK) virgins super hub (I think its Netgear CG3101D, not 100 sure The web interface to the HP Jetdirect 170x boxes includes a Scan. It also has an RJ-45 network port (10Base-T) for connecting the network.
HP JETDIRECT 170X MOTOM SERIES
Unplug the power cord, then hold down the TEST button for 5 to 30 seconds while plugging in the power cord. The HP Jetdirect 170X has a single high-speed, bidirectional parallel port (IEEE 1284) for connecting your device. HP Jetdirect 170x Print Server series Choose a different product series Warranty status: Unspecified - Check warranty status Manufacturer warranty has.
You can get it back to the default address by doing a cold reset.
If JetDirect 170x has been used on a real network then the address will almost certainly have been changed.
0 kommentar(er)
